The use of Bricks or Pavers to create a sidewalk or patio matches a home in a method that is unrivaled. In addition, setting up a Brick or Paver pathway does not necessarily require a pro.
The secret to setting up a Brick or Paver Walkway is to first appropriately prepare the area where the bricks/pavers are to be installed. The area needs to be removed at least a foot down, removing all topsoil and clay soil. In addition, string lines must be strung on each side of the pathway. The string lines show the finished height of the pathway.
As soon as the area has been dug down, 3/4" gravel stone need to be laid in and tamped down firmly. The height between the tamped down sand and the stringline should equate to the density of the brick or paver.
Now that you have a steady base, put a 1" pipe or journal board the length of the sidewalk on either side of the pathway. Utilizing a flatedge, e.g. a 2"x4" board, slide it over the two lengths of the pipe/ledger board. In doing this you will produce a level area to lay the bricks/pavers.
Now put on the level sand/stone dust strips of plastic brick borders. Set up a run on both sides of the prepared location. These strips will function as your walkway border and assistance to keep the integrity and shape of the sidewalk. You can get these plastic strip borders at a lot of home improvement stores. The strips must be anchored down with 12" galvinized nails. You need to sink these nails into the ground and through the strips every foot.
You can then begin to lay the bricks/pavers when this is done. There are lots of patterns you can lay. I especially like the Herring Bone pattern. The key to laying the bricks/pavers is to ensure that they interlock with each other. Constantly stagger adjacent rows of bricks by 1/2 of a brick to interlock them. This will again help preserve the integrity of the pathway.
Inevitably bricks/pavers will need to be cut or split when developing the pathway. Unless you wish to buy or rent an expensive wetsaw, I get more info would suggest purchasing a simple brick/paver splitter. It is basically a sculpt with a large end that is the width of the bricks/pavers. To in fact cut/split the brick/paver, lay it in a bed of sand and location the sculpt at a 75 degree angle over the spot where you wish to break the brick. Utilizing a hammer strike the butt end of the chisel firmly. You may require to do this a couple of times. You may likewise desire to turn the brick/paver over and strike the opposite of the brick using the hammer and chisle. Within a couple of strikes the brick/paver need to break easily. , if your pathway has curves you will require to buy/rent a wetsaw.
.
After installing the bricks, build up the outside edges with extra sand, and after that shovel in the topsoil and pack down securely.
Spread stone dust over the brand-new pathway and sweep into the fractures. This will finish the interlocking of the bricks and help to remove any weed growth.
In addition, setting up a Brick or Paver walkway does not always require a pro. The key to installing a Brick or Paver Walkway is to very first appropriately prepare the area where the bricks/pavers are to be installed. Now that you have a stable base, position a 1" pipe or journal board the length of the walkway on either side of the sidewalk. These strips will act as your walkway border and aid to preserve the integrity and shape of the sidewalk. Inevitably bricks/pavers will require to be cut or divided when building the walkway.